diff options
Diffstat (limited to 'Doc/Zsh')
| -rw-r--r-- | Doc/Zsh/compwid.yo | 18 |
1 files changed, 10 insertions, 8 deletions
diff --git a/Doc/Zsh/compwid.yo b/Doc/Zsh/compwid.yo index 05b8ab9b2..dcf2d1569 100644 --- a/Doc/Zsh/compwid.yo +++ b/Doc/Zsh/compwid.yo @@ -942,14 +942,16 @@ line match the corresponding upper case character in the trial completion you can use `tt(m:{[:lower:]}={[:upper:]})'. Although the matching system does not yet handle multibyte characters, this is likely to be a future extension, at which point this syntax will handle -arbitrary alphabets; hence this form, rather than the use of explicit -ranges, is the recommended form. In other cases -`tt([:)var(name)tt(:])' forms are allowed. If the two forms on the left -and right are the same, the characters must match exactly. In remaining -cases, the corresponding tests are applied to both characters, but they -are not otherwise constrained; any matching character in one set goes -with any matching character in the other set: this is equivalent to the -behaviour of ordinary character classes. +arbitrary alphabets; until then it is safer to use the older syntax +that only handles ASCII characters, `tt(m:{a-z}={A-Z}) as this does +not have side effects in the case of multibyte characters. + +In other cases `tt([:)var(name)tt(:])' forms are allowed. If the two forms +on the left and right are the same, the characters must match exactly. In +remaining cases, the corresponding tests are applied to both characters, +but they are not otherwise constrained; any matching character in one set +goes with any matching character in the other set: this is equivalent to +the behaviour of ordinary character classes. The pattern var(tpat) may also be one or two stars, `tt(*)' or `tt(**)'. This means that the pattern on the command line can match |