G. Pape
runit
svwaitdown - waits for services controlled by runsv(8) or supervise(8)
to be down
svwaitdown [ -v ] [ -k ] [ -t sec ] services
services
consists of one or more arguments. Each service directory must start with
a slash.
svwaitdown sends each service given at the command line the ‘‘down’’
command, and waits for it to become down. The services given at the command
line must be controlled by runsv(8), or supervise(8).
svwaitdown blocks,
limited by a timeout, until all services are down or reports errors.
- -v
- verbose. Print verbose messages to stderr.
- -t sec
- Set the timeout for waiting
for services to become down to sec seconds. sec must be between 2 and 6000.
Default is 600 (10 minutes).
- -k
- Kill. If the timeout is reached before all
services are down, tell the runsv(8) processes to send the services a KILL
signal.
- -x
- Exit. Send each service the ‘‘exit’’ command additionally to the ‘‘down’’
command, and wait for the corresponding runsv(8) processes to exit instead
for the services to be down. This option should only be used by runit(8)
in stage 3 when runsvdir(8) is already stopped.
svwaitdown returns
0 as soon as all services are down.
If a service is usually controlled by
runsv (8) or supervise(8), but no supervisor process is currently running,
svwaitdown treats this service as if it would be down.
For each service
that causes an error while checking, svwaitdown increases the exit code
by one and exits non zero. The maximum is 100.
svwaitdown returns 111 if
the timeout sec was reached.
svwaitup(8), runsv(8), runsvctrl(8),
runsvstat(8), chpst(8), svlogd(8), runit(8), runit-init(8), runsvdir(8),
runsvchdir(8), utmpset(8)
http://smarden.org/runit/
http://cr.yp.to/daemontools.html
Gerrit Pape <pape@smarden.org>
Table of Contents