diff options
Diffstat (limited to 'manual/charset.texi')
| -rw-r--r-- | manual/charset.texi | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/manual/charset.texi b/manual/charset.texi index b2d73abc1e..68aecd3f1e 100644 --- a/manual/charset.texi +++ b/manual/charset.texi @@ -1709,7 +1709,7 @@ implementation has the possibility to perform such a conversion, the function returns a handle. If the wanted conversion is not available, the @code{iconv_open} function -returns @code{(iconv_t) -1}. In this case the global variable +returns @code{(iconv_t) -1}. In this case the global variable @code{errno} can have the following values: @table @code @@ -1838,7 +1838,7 @@ implementation chosen for @theglibc{} as it is described below. Therefore an @code{iconv} call to reset the state should always be performed if some protocol requires this for the output text. -The conversion stops for one of three reasons. The first is that all +The conversion stops for one of three reasons. The first is that all characters from the input buffer are converted. This actually can mean two things: either all bytes from the input buffer are consumed or there are some bytes at the end of the buffer that possibly can form a @@ -2133,7 +2133,7 @@ will succeed, but how to find @math{@cal{B}}? Unfortunately, the answer is: there is no general solution. On some systems guessing might help. On those systems most character sets can -convert to and from UTF-8 encoded @w{ISO 10646} or Unicode text. Beside +convert to and from UTF-8 encoded @w{ISO 10646} or Unicode text. Beside this only some very system-specific methods can help. Since the conversion functions come from loadable modules and these modules must be stored somewhere in the filesystem, one @emph{could} try to find them @@ -2333,7 +2333,7 @@ identical. So far this section has described how modules are located and considered to be used. What remains to be described is the interface of the modules -so that one can write new ones. This section describes the interface as +so that one can write new ones. This section describes the interface as it is in use in January 1999. The interface will change a bit in the future but, with luck, only in an upwardly compatible way. @@ -2918,7 +2918,7 @@ gconv (struct __gconv_step *step, struct __gconv_step_data *data, /* @r{Run the conversion loop. @code{status} is set} @r{appropriately afterwards.} */ - /* @r{If this is the last step, leave the loop. There is} + /* @r{If this is the last step, leave the loop. There is} @r{nothing we can do.} */ if (data->__is_last) @{ |